My Due still works ok and the uno now actually says 'Arduino Uno' in the IDE for the port - which is good when I am developing for both at once. Note: Something good did happen with all my screwing around. I can return the card but after a couple of days on and off trying to get this to work I am starting to get belligerent Is it possible that the pcscd daemon sees the card but can't configure it (as a smart card) and it does not allow the pl2303 extension to have a go? Pcscd : Non-smartcard device launched pcscd ĭoes a 'real' mega 2560 use the same chipset for the serial port. plist to add the vender/device (6790,29987) but still and enormous amount of nothing. I have put in pl2303 drivers (in /system/Library/Extensions - after configuring the. My research says it is a HL-340 which is based on the prolific pl2303 chipset. Looking at System information, I can see the following Ĭurrent Required (mA): Unknown (Device has not been configured) When I connect the board, blink (I assume preloaded) does the flashy thing at 1 second intervals - so the basic board functionality works. The board is a DccEle - DCcduino Mega 2560 I have beating my head against the wall all weekend over this.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |